STEEL BUILDINGS ROOF SHEETING INSTALLATION
STEP 3
The numbers shown on the roof sheeting below indicate the order
of which they are to be applied. Note the ladder detail showing easy
access while on the roof and the ridge cap detail for buildings with
steep roof pitches.
RIDGE CAP DETAIL
CAUTION: NEVER walk on or step on High-rib part of sheet.
Always walk on lower part of sheeting where it is fastened to the
roof purlin.
Notice: Install your ridge cap
panel as the roof sheets are installed. Do not place all your roof
sheets, then go back and place your ridge caps later.
SAFETY SHEETING LADDER DETAIL
A method of moving on the roof to prevent sheeting damage
between purlins. Also used for your support on higher pitched roofs.
CAUTION: If not using a sheeting ladder, always lay down
a board support 2"x8"x10' or larger to walk on roof sheeting between
purlins.
<-- previous page
Steel Building
Manual
next page Steel Building
Manual -->
| 