STEEL BUILDINGS CABLE BRACE GRIP APPLICATION
INSTRUCTIONS
1. Insert one leg through the eye. Apply thumb pressure to hold
the end of the strand at the crossover mark as shown.
2. Apply the first two pitch lengths to the strand. (A pitch
length is one complete wrap around the strand - see picture.) NOTE:
From this point on, the leg may be rotated out and away from the
strand, making the application easier. Apply one more pitch length
as shown.
3. Match the crossover marks and apply the other leg...
4. ...except for the last two pitch lengths.
5. For ease of application, split the legs as shown.
6. Apply each split section separately. With proper thumb
pressure, snap the rod ends into place. Make sure all rod ends are
secured.
7. The Brace Grip completely applied to strand and eyebolt.
Duplicate this procedure for the other end of the strand to the
brace eye.
<-- previous page Steel
Building
manual
next page Steel Building
manual-->
| 